Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Goodman Furnace Model GMPN100-4--No Heat
[ 3 Answers ]
The inducer fan motor starts,the hot surface igniter heats up and the gas valve opens producing a nice blue flame for 3 or 4 seconds and the gas valve shuts off. There are no red flashing lights to indicate a problem with any components. This unit was built around 1993. Any ideas on what might be...
Goodman furnace model GMT 015-3
[ 1 Answers ]
The blower works when thermostat is switched to Fan, but there is not heat. Once I switch to Auto, there is not heat and the blower does not work. Temperature is set above the current room temperature. Would that be caused by a board issue? The red light just stays on, does not blink at...
Goodman ac model gmpn100-4
[ 1 Answers ]
On the control panel circuit board b18099-13 I would like to know where the red blue and black wires from the blower motor connect to this board were these wires conect are m1 m2 heat cool and eac are a couple for speed control I would like to make it run faster the air coming out is like on...
Goodman model gmpn080-4
[ 4 Answers ]
Have a goodman model gmpn080-4 I lost blower limit pressure switch previously and seemed to be the same thing, ordered part and still does same thing. Thought it may have had a vacuum leak so I sealed the edges, as long as it is not connected (securely) to the exhaust pipe it runs fine. As soon as...
Goodman Model A32-15
[ 1 Answers ]
I understand how ot wire abasic thermostat but on my Goodman I have OTC-OT1-OT2 & OT3. What are these for? View more questions Search
|