Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Goodman Furnace Model GMPN100-4--No Heat
[ 3 Answers ]
The inducer fan motor starts,the hot surface igniter heats up and the gas valve opens producing a nice blue flame for 3 or 4 seconds and the gas valve shuts off. There are no red flashing lights to indicate a problem with any components. This unit was built around 1993. Any ideas on what might be...
Goodman Furnace Model GMPN060-3 Three Blinks Diagnostics.
[ 7 Answers ]
I have a Goodman Furnace Model GMPN060-3. I get three blinks biagnostic code. I changed venter (motor assembly) and pressure switch. Still the same three blinks. Moisture drain path is clean and free of debries. After the new parts, furnace started once, but would not start again -- same three...
Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset
[ 5 Answers ]
I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...
Goodman Furnace Model GMPN080-4 one red blink
[ 3 Answers ]
Furnace turns on the igniter glows but does not ignite (the gas valve is not turning on) it does this 3 times before turning off the circuit board blinks 1 time.. I replaced the flame sensor and it still does the same thing checked the gas valve and its not getting 24volts to it.. anybody have any...
Goodman Model A32-15
[ 1 Answers ]
I understand how ot wire abasic thermostat but on my Goodman I have OTC-OT1-OT2 & OT3. What are these for? View more questions Search
|