Ask Experts Questions for FREE Help !
Ask
    kenny kellon's Avatar
    kenny kellon Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 26, 2009, 01:30 PM
    bryant heater codes model 588anw036100aaaf
    Unit will not start without disconnecting power then will not shut off at set temp. Replaced thermostat-no help. LED blinks 8x,, PC board looks to have gotten real hot around 2 resistors on left side below a relay. Any ideas what the blink-code means??
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Dec 26, 2009, 02:03 PM

    Blink codes should be on the inside of the access door. We can look further.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #3

    Dec 26, 2009, 03:58 PM

    If you can see physical sings of overheating on the control board, you are most likely going to need a new board. If the baord has melted or burnt in any areas, flash code may very well be giving a false code.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant 373LAV trouble codes [ 2 Answers ]

My Bryant 373LAV appears locked out. The trouble code is 3 short and 1 long. The trouble code sticker is missing from the blower door. Can anyone identify the code's meaning?

Bryant Error Codes [ 1 Answers ]

Trying to find error codes for Bryant Furnace it's 7 years old (can't read the model #) I am getting 4 slow red flashes followed by 3 quick ones. Thanks for any help.

As to the bryant gaspack codes [ 1 Answers ]

The error code said processor detected error in software or hardware. It has a code for flame sensor.

Bryant Gaspack LED codes [ 1 Answers ]

I have a 588ANW048120 gaspac and the code led refers to the IGC error, I can reset the unit by cutting off main power and it comes on and works ofay for awhile then all of a sudden it does the same thing. Sometimes it will work OK for aday or two then again it may go and do it two times in one day....

Bryant gas heater model beginning 310aav [ 3 Answers ]

I had not used my furnace over the summer. Before turning on the thermostat, I replaced the filter and checked to make sure red light was on solid. Turned on thermostat and furnace light started blinking error code 23, which according to list on furnace means pressure switch obstructed or off. I...

View more questions Search