 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Heat pump thermostat wiring
I am trying to install a new Honeywell heat pump thermostat model TH5220D1003. I have looked at the installation manual and I am not sure of the correct connections. It list wires I do not have. I am not sure if the original wiring at the heat pump is correct. At the Rudd heat pump I have six wires; Blue, Yellow, Brown, Red, Green, White/Black. On the new thermostat I have L, E, Aux, G, O/B, C, Y, R, Rc ( R & Rc are jumpered together) Should I also jumper for emergency heat. The Rudd manual says I should install a jumper for emergency heat but I am not sure where since the diagram appears to be wrong. Need help!
|
||||
Check out some similar questions!
Simple comfort 2200 to a Honeywell RTH7500. C-blue G-green Y-yellow O-orange R-Red E-Black B-Brown
My system has a Heat Pump and Emergency heat back up. I want to replace the thermostat but need help, as I don't work on heat pumps very often. Ok, her is the color wires I have coming out of the wall and connected to my old thermostat. Red wire connected to (R) Green wire connected to (G)...
I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -
I am installing a Honeywell RHT7000 thermostat. My wiring harness has a r, o,y,g,c, and w1. On the old unit e and W1 were jumpered. What do I do when the instructions say to contact a contractor if the new wiring scenario has a w1?
I have pored over the thermostat wiring messages on this forum, but I still have a question. I am installing a RiteTemp 8085C to replace a Janitrol thermostat for my Goodman heat pump. The old thermostat was wired as follows: Red to R Orange to O Yellow to Y Green to G Blue to C White...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
