Ask Experts Questions for FREE Help !
Ask
    Esphilo's Avatar
    Esphilo Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 2, 2009, 12:56 PM
    Honda CRV fails to start sometimes
    It's a 2009 Honda CRV EX and fails to start after the engine is warm. It takes 3 or 4 tries before the engine will start. Why is that?

    Ed
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Dec 2, 2009, 01:43 PM

    . Check for codes.

    . Check/replace the Crankshaft Position Sensor.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Exhaust Blower fails to start on gas furnace [ 2 Answers ]

I have a tempstar furnace model # FBF075B12G1. The furnace is maybe 3 years old. The little motor which turns the exhaust gas blower feels a little hard to turn. There is some rust on top of it. It will sometimes fail to start, which keep the burners from kicking in. If I spin it by hand, it will...

Lennox G20 gas furnace fails to start the fan [ 6 Answers ]

My Lennox G20 gas furnace ignites the pilot light and starts the main burners. The burners burn normally for about 2 minutes and shut down without the blower fan starting. If I manually set the blower fan to run continuously, the heater cycles on heats the house to the temperature set on the...

22 HP Kohler Engine Fails to Start [ 4 Answers ]

I've replaced the plugs, fuel/air filters and verified the fuel pump worked. Used starter fluid, and engine started but did not continue to run. Suggestions?

2001 grand am fails to start (water damage) [ 6 Answers ]

I have a 2001 Grand am and I drove it through a large puddle of water last night I went this morning and it wouldn't turn over. The water did make it just underneath the door and I pushed the car to a high and dry spot. What are the possibilities of the car starting back up on it's own without...

Condenser fan fails to start intermittently [ 1 Answers ]

Condenser fan sometimes fails to start (notably after its been running for some time). After I de-energize the unit for ~ 1/2 hr, it it then starts up. 1. Do I need to replace fan and capacitor? 2. The installed capacitor has 3 leads with a resistor across 2 terminals. Do I find a like...

View more questions Search