Ask Experts Questions for FREE Help !
Ask
    wilbur57's Avatar
    wilbur57 Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 25, 2009, 05:58 PM
    we built a new polebarn we want to run a 200amp electrical box in it what do we need?
    we had a 24x40 pole barn built and we want to run a 200 amp electrical box the electrical company will hook up to it what do I need from the inside?
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
     
    #2

    Nov 25, 2009, 06:15 PM

    What exactly are you asking? Do you need every last detail and material item explained?

    What experience do you have?
    OoooOoooMeMeMea's Avatar
    OoooOoooMeMeMea Posts: 12, Reputation: 2
    New Member
     
    #3

    Nov 26, 2009, 10:12 PM

    You should check with your power company first and make sure you have every thing right. They will usually give you a spec sheet that gives you the details. Usually a 200amp service panel with a main disconnect breaker inside connected via conduit to a meter base on the outside. And grounded to a ground rod driven into the ground very close to the panel. If you don't have experience in this type of work, you should really have this work done by a lic. Electrician. I would think that your power company and local gov. would require this work be done by a lic. Electrician.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Long electrical run. [ 4 Answers ]

I am putting in a powered gate across my road. What size wire would I use? It is a 200yd run from the nearest power pole.

200amp main panel with 200amp sub panel [ 6 Answers ]

Hi - I'm in Colorado and about to do an electrical service panel upgrade along with a sub panel install. (I should note here that I am an electrician - Australian, so the rules I'm used to are different here in the US). I've applied for and received the relevant permit from the city, but...

Wiring my polebarn underground to my house [ 4 Answers ]

Overview-- Ran undergound conduit from polebarn to home. Ran #4 black(power)#4 Red(power)#4 White (Neutal) #8 Ground. Going to use polebarn for general lighting/outlets, but possible later might use a welder, that's why I ran the extra power lead. Going to wire polebarn panel first, to a 100 amp...

Installing built-in Microwave over built-in walloven [ 5 Answers ]

We purchased a Jenn Air built-in microwave and want to install it right above the built-in Jenn Air wall oven (so it looks like one unit, or close to that) How much space is recommended between the 2 pcs? The installation instructions are pathetic and do not say. We tired calling them and of...

Electrical Rewire a Entire Home built in 1944- 1951 ? [ 2 Answers ]

I had a inspector inspect my home to sell. He identified two prong outlets in kitchen needed to be replaced with gfi outlets. Ok done ! But also mention that several other plugs and 100 amp panel was ungrounded and not safe. Had electrian come out, he reccomened to rewire the entire home for $...


View more questions Search