Ask Experts Questions for FREE Help !
Ask
    ariesfs's Avatar
    ariesfs Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 16, 2009, 07:00 PM
    Air filter replacement for amana 80sse house furance
    I can not find anywhere on this unit the size of the air filter. Some had put a 20" filter in the unit but you can see it was forced in the it's location. After removeal I could see an upper and lower rail for a filter to slide into. But can not deturemen is size. And after attempting to locate a heating services that might advise me, all I get is that they want to send some out to tell it's size for a price. Can any one advise m?

    Thank you

    Frank
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Nov 16, 2009, 07:42 PM

    It the slot on the outside of your unit, or inside the unit?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Amana AMS8 blows cool air [ 2 Answers ]

Ever since having a new furnace installed, it has never actually put out HOT air... it blows cool air, gradually warming, but never actually warm. Until the fan stops, and then some warm air trickles out of the duct

Hi-limit switch failure on Amana gas furnace model 80SSE [ 0 Answers ]

Four blinks says reset hi-limit switch. Could not reset stuck button so I replaced it. Still blinks four times. What can I try next?

Amana microwave.door handle replacement. [ 2 Answers ]

I have an Amana MVH210E "over the stove" microwave. The handle has broken off and must be replaced. I can't figure out how to disassemble the door to gain access to the fasteners that screw into the handle. Can anyone out there offer a suggestion?

Amana GSC 125A 90% furance [ 1 Answers ]

I have a forced hot air Amana GSC 90 furnace. Electronic ignition. Power goes to the broad and noting happen. No ignition. The draft motor gets hot, but want run. I replace the ignition broad and pressure value and have the same problem. The unit will not ignite the burner. If I turn the fan switch...

Amana 80SSE running on Generator [ 2 Answers ]

We have an Amana 80 SSE and have it wired so that we can unplug the furnace from the electrical connection and plug it into a generator. We have tried this several times and it will start the blower and ignite the pilot but will not keep the furnace lit for more than about 10 or 15 seconds. ...

View more questions Search