Ask Experts Questions for FREE Help !
Ask
    cwhead's Avatar
    cwhead Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 8, 2008, 12:40 PM
    Amana GSC 125A 90% furance
    I have a forced hot air Amana GSC 90 furnace. Electronic ignition. Power goes to the broad and noting happen. No ignition. The draft motor gets hot, but want run. I replace the ignition broad and pressure value and have the same problem. The unit will not ignite the burner. If I turn the fan switch to run, the blower comes on and run. Can someone advised?
    acetc's Avatar
    acetc Posts: 1,004, Reputation: 79
    Ultra Member
    		  
    #2

    Jan 8, 2008, 02:33 PM
    Sounds like you have a bad induced draft motor, Good luck, Mike
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furance cut in / out too much [ 1 Answers ]

I have a bryant furance, we moved in a couple of weeks now. The furanace cycles in and out too much, from start up to shut down it last 9mins. Any Ideas what it might be. Thanks.

Furance not turning on with auto [ 1 Answers ]

When I set the tempture up to 80 degrees on the thermometer and turn to auto the heat does not switch on? Our pilot light is lite and when I turn the heat on it only cool air comes out. Any ideas? Thanks for the help!

Oil furance [ 2 Answers ]

My oil furance won't light it is a beckett afg model how can I light

Furance works once, doesn't restart [ 5 Answers ]

A problem recently developed with my furnace. I increase the thermostat and I hear the furnace "click" on. I see the orange ignition light turn on and the flame begins to flow within 10 seconds or so and then the orange light fades away and the hot air flows - which I presume is normal. The...

View more questions Search