Ask Experts Questions for FREE Help !
Ask
    TRoberts8's Avatar
    TRoberts8 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 24, 2009, 08:56 AM
    Goodman control panel
    Just installed-by a licenced friend- a new high effic. Goodman gas furnace- fired up okay for a couple of hours-now it is not- fan comes on- diagnostic panel is blank- breaker is okay, 3 amp fuse is okay, flame sensor reads only 57 volts(should be 120?)- installer figures control panel is fried. Is that most likely? If so going to be chilly till I get a new one.
    Thanks
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Oct 24, 2009, 01:46 PM
    See here
    Attached Images
  1. File Type: pdf Doc1.pdf (42.4 KB, 129 views)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman furnace frying control boards [ 3 Answers ]

I have a 1999 Goodman model gsm060 that keeps frying boards. Have had this furnace in my shop for 10 yrs under the same conditions. Last heating season the board went bad. I replaced it and it lasted 2 weeks. And went bad. Had local shop come out being board was not under warranty due to me...

Control Panel [ 2 Answers ]

I am trying to get to my control panel but evey time I click on it a pop up screen comes up and says, Windows explorer is shutting down. Then logs off the laptop and starts up again. PC world could not help they say they have not seen this before.

Goodman cpke 30-18 control issue [ 3 Answers ]

I Have a goodman heatpump/air conditioner and the inside blower does not come on causing the compressor to ice up. If I play with the blower controles then it comes on but a few days later it happens again. Only in Air not heat. I replaced the controls (thermostat) no joy.. any help?

Goodman AE 24-08 Blower/control issues? [ 7 Answers ]

Hi, I have a Goodman AE 24-08 interior blower unit for my heat pump. Recently the blower stopped turning on, while the outside unit would run. Checking in the panel, the motor was trying to kick over, but couldn't get started. If I turned the blower by hand, (to get it started), it would run...

Control panel [ 1 Answers ]

When I click on Add Remove programs I can’t see my current programs I’m using windows XP professional Also Control panel items not display :rolleyes:

View more questions Search