No flame on Amana 80 SV furnace

rgadiarte Posts: 1, Reputation: 1

New Member

Oct 24, 2009, 05:23 AM

No flame on Amana 80 SV furnace

New filter; turned thermostat on; blower runs but no flame. What could be the problem?
Igniter? Flame sensor? I am not a techie so please give detailed description of how to troubleshoot. Thanks.

Check out some similar questions!

Amana furnace [ 2 Answers ]

Hi Everyone, I am having so much trouble, trouble shooting my furnace, I have a Amana Furnace, I noticed that the Burner is not staying long enough for the heat to blow through the vent. This is my observation, once adjusted the temp desired in the thermostat, the burner on the furnace...

Gas furnace - no flame [ 4 Answers ]

Hope someone out there can help, because it's going to get cold this weekend! I have a split HVAC unit with furnace in attic. Written on front of unit is Intertherm. Inside panel of unit says Nordyne, and the Ignition Control is Robert Shaw. The unit is 13 years old and the heat worked fine...

Amana furnace [ 2 Answers ]

I misplace the wiring diagram and installation manual for my Amana Furnace. Any chance someone, website may have a good source for that: Mod # GUCO70B40A, Serial # 9110104173, Mfg # P9114303F Suggestions for a fix would be appreciated also: Having problems starting. The igniter works fine...

I have an Amana 80+ furnace. [ 1 Answers ]

When the temperature reaches the desired setting, the gas burners turn off as they should, however the fan continues to run and blows cold air. The temperature dips well below the thermostat setting, but the burners do not turn back on and the fan continues to run. I also notice a flashing red...

View more questions Search

Check out some similar questions!

Add your answer here.