Ask Experts Questions for FREE Help !
Ask
    panther1029's Avatar
    panther1029 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 20, 2009, 04:02 PM
    Why won't my acura start?
    I have a 1990 acura integra that is a 5 speed. I have replaced the battery the starter and the alternator and it still won't start. Why?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Oct 20, 2009, 04:37 PM

    Perform tests, in Sections 1 and 2 below:

    https://www.askmehelpdesk.com/cars-t...les-46563.html

    If the CEL comes on and goes off normally, replace the Ignition Control Module (ICM) and coil:

    https://www.askmehelpdesk.com/cars-t...tml#post265896
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1997 honda civic dx won't crank won't start [ 17 Answers ]

I have a 1997 honda civic dx 5 speed. Yesterday car was fine, started strong and drove strong. I parked car last night and about 4-5 hours later tried to start it. When I turned the key in the ignition there was no crank at all. I can hear a little hum and then a click but that's all.

Saturn won't start, power locks won't work, radio resets itself. [ 4 Answers ]

My 99 Saturn has had some starting problems in the past. It would sometimes not start but if you let it sit from anywhere from 45 minutes to 24 hours, it would eventually start. Or, after having Dad look at it, we could tap the starter and it would work. So we thought it was the starter. I...

1999 Acura 1.6 EL won't start and no dash lights [ 5 Answers ]

I have a 1999 Acura 1.6 EL which is basically a 1999 Honda Civic Si... D series engine 1.6 litre... 5 speed manual tranny. Anyhow, car was fine until today. Now when I go to start it I get nothing. No dash lights come on at all. No interior lights will come on. No headlights will come on...

Kenmore he4 panel won't work and dryer won't start [ 1 Answers ]

I have had the circuit board/panel replaced once on my he4. I had only 2 weeks left on the warranty and figured it should be OK once it was fixed. They wanted another $200 to renew the warranty! Didn't have the $$ at the time. Anyway, the same darn thing is happening... you have to push the buttons...

View more questions Search