Ask Experts Questions for FREE Help !
Ask
    rampboss's Avatar
    rampboss Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 15, 2009, 12:54 PM
    Remote inop.
    Remote stopped working. :(

    New batt and still no go.
    FCC ID L3hmy97fanhd

    Repair tips or new one.
    Thank you
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Sep 15, 2009, 05:44 PM

    Brand/model would meam more to us. Open the back cover, does it have dip switches, do they match perfectly the switches in the receiver? Does a small red light come on when you push buttons?
    ceilingfanrepair's Avatar
    ceilingfanrepair Posts: 5,733, Reputation: 109
    Uber Member
    		  
    #3

    Sep 15, 2009, 07:45 PM

    Does the LED on the remote light up?

    Ceiling fan remote controls - help and FAQ- Ceiling Fans N More
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Lennox 2 speed inop. [ 1 Answers ]

I have a lennox 2 speed condensing unit that is 25 yrs old and had very little problems with it. I cut the unit on last week and nothing. I took the panel off the outside unit to ck to see if I had voltage at the transformer and voltage coming from the house all good. I pushed the contactor in for...

Telephone inop [ 1 Answers ]

I have ATT DSL which uses the same line as the telephone. This morning the phones worked but tonight I do not have a single phone in the house that works. No dial tone but yet the DSL works fine. I have gone through house unpluging the filters one at a time but still don't have a dial tone. No...

Day & Night Gas heat INOP [ 3 Answers ]

I have a Day & night model 588, the ignition circuit board LED indicates a fault #8 (internal control fault). Are there voltage checks to confirm that the circuit board needs replacement.

2000 Silverado - 4x4 inop [ 2 Answers ]

2000 Silverado 1500 keeps showing Service 4WD light... we replaced the switch in the dash, the encoder motor on the transfer case, the actuator, the module behind the switch, checked the ground wires, traced all of the wiring... nothing's worked! :mad: Occasionally, when you switch the key on...

View more questions Search