Ask Experts Questions for FREE Help !
Ask
    krknight's Avatar
    krknight Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 26, 2009, 02:15 PM
    Blowing Fuses
    I have a John Deere L110. It will start but blows fuses? What could be the problem?:(
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Jul 26, 2009, 02:19 PM

    Short anywhere in the harness. Does any one action cause the fuse to blow like lower the deck or engaging the blades?
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #3

    Jul 26, 2009, 04:21 PM

    Hi,
    It did not occur on the L110 that I really saw, but on the L120 and L130 there was a problem with the rear harness. Look along the right hand side of the frame at the harness that goes to the seat switch for damage; trace it from the seat if necessary.
    That is the first place to look. Part #GY20168 if needed.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Blowing fuses [ 1 Answers ]

Hi I have a intertherm furnace model #FEHA-017HAC-01 with a fuse "panel" 2-30 amps and 2-60 amps the 60 amp fuse on one side burns out about every week or so I also notice the disconect "plug" is getting hot on this burnt fuse side as it is starting to discolour and deforme melted any suggestions?

Fuses blowing [ 2 Answers ]

Hello. I hope someone can help me. I have a 38” Weed Eater riding mower with a 12.5 hp Briggs & Stratton engine. I keep blowing the 30 amp fuse that is located right next to the battery. I can change out the fuse with a new one and the mower will fire right up and run great. I am not sure at...

Blowing fuses [ 1 Answers ]

York heat pump,Have cold air all summer,fan alone runs fine,emergency heat works great,But when you turn it to heat only it will blow fuse,could it be a control board on the inside... Thats what I'm being told now.. by a service tech... By the way THANKS for the help so far... Heater coils have...

Blowing fuses [ 1 Answers ]

Had new thermostat installed,most everything on this york unit has been checked,couldn't find a problem,boards,contacts,relays all checked out to be fine,still blowing 5 amp fuse when calling for heat??

Fuses blowing [ 2 Answers ]

:confused: My clothes dryer started blowing fuses. Since it was a 1964 model, we assumed it was on it's last legs and bought a new one. The new dryer is also starting to blow fuses. The dryer is on a separate fuse box from everything else. Nothing has changed where the dryer or fuse box was...

View more questions Search