Ask Experts Questions for FREE Help !
Ask
    doreeng's Avatar
    doreeng Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 23, 2009, 02:40 AM
    Blower stays on after turning A/C on or off.
    I am trying to figure out why the blower remains on even when the A/C is turned off. It has been running for days. It has been over 105 degrees. Extreme heat. What could be the problem? Only turns off when I remove front panel where I replace filter.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    Jul 23, 2009, 11:41 AM
    ,, are you sure the tstat is set to auto instead of set to fan/fan only

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Blower stays on [ 2 Answers ]

I have an old Bryant heater and the burners won't stay on until the thermostat setting is reached. The blower stays on but the burners will cycle on and off in short intervals.

Blower stays on [ 4 Answers ]

My blower fan on the inside unit stays on after thermostat cuts off.. I have a lenox model CB30M-312P.. INSTALLED 11/2004

Furnace Blower stays on far too long [ 1 Answers ]

We have an older Tappan ANS Z21.47 furnace, circa 1979. When the cooler weather season started this year we turned on the heat and noticed that once the house had reached the correct temperature then the blower would remain on and blow cooler air for at least 20 minutes afterwards. We had read...

Blower stays on [ 1 Answers ]

I am working on a Tempstar furnace, Furnace blower comes on even thermostat is fully disconected from control board. Replaced control board and limit switch. Furnace still coming on. Checked all the wire locations. Tempstar model is - NFCX3600C1 Serial is- L001362305 Any...

Blower Fan stays on when it should not [ 2 Answers ]

New Amana heat pump system: outdoor unit ASZ140481A, indoor unit (in attic) AEPF426016B + TXV. Thermostat: TotalTouch P286-200. When fan setting is FAN AUTO and the system is not cooling or heating, the fan can come on and stay on for hours, or the fan stays on after heating/cooling stops. The...


View more questions Search