Ask Experts Questions for FREE Help !
Ask
    mikeshbike's Avatar
    mikeshbike Posts: 1, Reputation: 1
    New Member
     
    #1

    Apr 18, 2009, 03:12 PM
    Briggs and Stratton 14.5 HP mower engine poor performance
    I am just getting my rider mower running after two years sitting. I put in new gas, flush gas line, new gas filter, new plug, new oil, new oil filter. Would only start with starter fluid. I cleaned out carburator, drained gas, spray with carb cleaner, re-assembled. It starts now but only runs medium throttle and full choke. More throttle or less choke stops the engine. What is the problem? Is it carb? Will running a while with cleaner perhaps fix problem? New carb needed? This is a Briggs and Stratton 14.5 OHC Quiet Series engine. Vertical shaft. Purchased in 2000.
    21boat's Avatar
    21boat Posts: 2,441, Reputation: 212
    Ultra Member
     
    #2

    Apr 18, 2009, 04:44 PM
    Quote Originally Posted by ;
    Is it carb? I cleaned out carburetor
    Is there needle valves on the crab and one for fuel and one for air? They could be bad themselves in the carb.

    It may just need a carb rebuild kit since its been sitting and or dirt In the carb ports.

    Fuel pump here could be weak and is not out of the question.

    I wouldn't get a new carb just rebuild what you have if you can't adjust the carb properly

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

20 hp Briggs and Stratton engine won't start -TroyBilt mower [ 4 Answers ]

I have a Troy Bilt riding mower and it won't start. The battery has been checked. I think it's the starter. Anyone know how to change the starter?

Briggs and Stratton engine [ 3 Answers ]

My Briggs and Stratton 10D902 lawnmower engine is running very rich. The air cleaner is OK Can you please advise

12.5 briggs and stratton lawn mower engine [ 1 Answers ]

Does the 12.5 briggs and stratton lawn mower have solid state ignition or does it have points under the flywheel? Thanks.

Briggs & Stratton 10 hp lawn mower engine? [ 1 Answers ]

Just wondering if the flywheel should be in contact with the starter at all times as it appears to be! It has eaten the flywheel gear off! Stupid nylon gear! Is there any after market alloy type replacement? Numbers off engine plate Model 28a707 Type 0113-01 Code 951103za

12.5hp I/C Briggs&Stratton engine [ 3 Answers ]

I went to start my riding mower for the first time this year and when it started is smoked real bad. I turned it off and checked the oil, it was over filled. I went to drain the oil and discovered it had gas in the oil. It ran fine last year, but I didn't drain the gas out at the end of the season....


View more questions Search