Ask Experts Questions for FREE Help !
Ask
    curtatparadox's Avatar
    curtatparadox Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 16, 2009, 07:48 AM
    Locate flame sensor
    Nordyne L1RA 054C-12A (Gas upflow furnace)

    Where is the flame sensor located and how is it removed?

    I have a diagram of a similar unit that identifies the major components but...
    The list has: 2 Flame Sensor (Not Shown)

    Is it hidden or hard to get to?

    Thanks,
    Curt
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Feb 16, 2009, 11:06 AM
    It might look like this.
    Attached Images
      

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Flame sensor [ 3 Answers ]

Need to clean flame sensor on Amana 80 Command. Where is the flame sensor? How should I "clean" it?

What does the flame sensor look like [ 3 Answers ]

What does the flame sensor look like and where is it located?

Bad Flame Sensor? [ 1 Answers ]

Thermostat calls for heat Blower comes on for 30 seconds Ignitor glows Gas kicks on & gas ignites in first burner Travels down the to the other three burners including the last one where the flame sensor resides Furnace stays lit for a few seconds and then goes out with a lockout code The...

Flame sensor [ 1 Answers ]

I have a York Diamond 80 upflow furnace. I think my flame sensor is bad. I checked my wire to the sensor with my meter ( I just completed classes in HVAC) and got 90 on the volts. Just wanted to make sure I am replacing the right part. The flame kicks on and goes out about 5-10 seconds later.

Flame Sensor [ 5 Answers ]

How can I replace a flame sensor in a Trane heating unit?


View more questions Search