Ask Experts Questions for FREE Help !
Ask
    dddcubed's Avatar
    dddcubed Posts: 4, Reputation: 1
    New Member
     
    #1

    Dec 14, 2008, 07:58 AM
    What does the flame sensor look like
    What does the flame sensor look like and where is it located?
    donf's Avatar
    donf Posts: 5,679, Reputation: 582
    Printers & Electronics Expert
     
    #2

    Dec 14, 2008, 08:07 AM

    OK,

    Can we all guess at the same time as to the type of equipment we are being asked about as well as it's model number?
    dddcubed's Avatar
    dddcubed Posts: 4, Reputation: 1
    New Member
     
    #3

    Dec 14, 2008, 08:34 AM

    Never mind I found it cleaned it and it's working fine thanks
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
     
    #4

    Dec 14, 2008, 09:32 AM

    The spirits are telling me it's... it's... oh wait, here come tomorrow's lottery numbers!.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Flame Sensor [ 2 Answers ]

I have a RHEEM furnace with a hot surface ignitor. The flame sensor will only register .01 microamps, not enough to keep the burners fired. What is the procedure for checking polarity for the furnace, and what could other possible causes be? The flame sensor is new, and the gas pressure is 3.5...

Corroded flame sensor [ 3 Answers ]

I have a Lennox (10 yrs. Old) furnace with a high quality air cleaner. (Filter new) My flame sensor has to be cleaned every 2 - 4 days (as the furnace goes out and blows cold air). It is continually getting corroded. The ceramic is totally intact. I clean the sensor with a fine wire...

Bad Flame Sensor? [ 1 Answers ]

Thermostat calls for heat Blower comes on for 30 seconds Ignitor glows Gas kicks on & gas ignites in first burner Travels down the to the other three burners including the last one where the flame sensor resides Furnace stays lit for a few seconds and then goes out with a lockout code The...

Flame sensor [ 1 Answers ]

I have a York Diamond 80 upflow furnace. I think my flame sensor is bad. I checked my wire to the sensor with my meter ( I just completed classes in HVAC) and got 90 on the volts. Just wanted to make sure I am replacing the right part. The flame kicks on and goes out about 5-10 seconds later.

Flame Sensor [ 5 Answers ]

How can I replace a flame sensor in a Trane heating unit?


View more questions Search