Ask Experts Questions for FREE Help !
Ask
    bwcochran's Avatar
    bwcochran Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 11, 2009, 03:06 PM
    Flame sensor
    Need to clean flame sensor on Amana 80 Command. Where is the flame sensor? How should I "clean" it?
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
    		  
    #2

    Jan 11, 2009, 03:17 PM
    Here comes another royalty... better than an I.R.A.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #3

    Jan 11, 2009, 03:31 PM
    Quote Originally Posted by KC13 View Post
    Here comes another royalty...better than an I.R.A.!

    Thank you.
    Attached Images
     
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #4

    Jan 11, 2009, 03:32 PM
    Your check for 1 and 1/4 cents is on the way
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Flame sensor [ 3 Answers ]

Being three days away from getting a new flame sensor, can the two broken pieces of the old flame sensor be effectively welded together? (rod is broken right behind ceramic insulator)

What does the flame sensor look like [ 3 Answers ]

What does the flame sensor look like and where is it located?

Flame Sensor [ 2 Answers ]

I have a RHEEM furnace with a hot surface ignitor. The flame sensor will only register .01 microamps, not enough to keep the burners fired. What is the procedure for checking polarity for the furnace, and what could other possible causes be? The flame sensor is new, and the gas pressure is 3.5...

Bad Flame Sensor? [ 1 Answers ]

Thermostat calls for heat Blower comes on for 30 seconds Ignitor glows Gas kicks on & gas ignites in first burner Travels down the to the other three burners including the last one where the flame sensor resides Furnace stays lit for a few seconds and then goes out with a lockout code The...

Flame sensor [ 1 Answers ]

I have a York Diamond 80 upflow furnace. I think my flame sensor is bad. I checked my wire to the sensor with my meter ( I just completed classes in HVAC) and got 90 on the volts. Just wanted to make sure I am replacing the right part. The flame kicks on and goes out about 5-10 seconds later.

View more questions Search