Ask Experts Questions for FREE Help !
Ask
    the salton's Avatar
    the salton Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Dec 30, 2008, 04:47 PM
    Kenmore washer only draws water
    Kenmore washer 4 yrs old, model # 110.25862400. Takes in water then nothing. How do I get it open to check switches.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Dec 30, 2008, 05:38 PM
    Most of the switches are located in the console on top of the unit and is you look around you will usually find a few screws to remove. The first item I would check is the pressure fill sensor switch. This will have a plactic or rubber line attached to it and also the tub. Its job is to sense the water fill level and turn on the unit when it is filled with water to the correct level.
    the salton's Avatar
    the salton Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Dec 30, 2008, 06:18 PM
    Quote Originally Posted by hvac1000 View Post
    Most of the switches are located in the console on top of the unit and is you look around you will usually find a few screws to remove. The first item I would check is the pressure fill sensor switch. This will have a plactic or rubber line attached to it and also the tub. Its job is to sense the water fill level and turn on the unit when it is filled with water to the correct level.
    The top is fastened to the back and the back panel is all one sheet of metal. I have taken it partially loose but, looks like the wrong procedure because of clips attached would be unable to reatach them. Also the washer will not function in any position of the dial except fill. It is level and has powere at the plug. Thanks
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #4

    Dec 30, 2008, 08:46 PM
    The console on the top of the top comes loose. The console contains the timer etc.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

No hot water in Kenmore 70 Series washer [ 3 Answers ]

I just replaced the hot/cold water valve in my Kenmore 70 Series Heavy Duty Plus washer model no. 82372110. I had one wire in the wiring harness, small, left over and couldn't find where to attach it. The washer fills fine with cold water but takes in no hor water. All lines and hoses are new...

Kenmore washer stopped with water in it [ 5 Answers ]

Washer stopped at the rinse cycle. Motor clicks to come on and immediately clicks off. This went on all night unbeknownst to me. What do I do?

Kenmore washer water leak [ 1 Answers ]

Kenmore washer, type 111, model #110.22642100, has water leaking from bottom of washer. I checked all hoses and all are clear and not clogges, could this be the pump and what does it look like, how much should it cost?

Kenmore washer still has water after spin cycle [ 1 Answers ]

I have a Kenmore washer 80 series model 110, After the spin cycle finishes there is still some water in the washing machine. We restart the cycle and then all the water is gone. This doesn't always happen, sometimes it works fine. Any ideas would be appreciated

View more questions Search