System goes into aux heat

dhyatt Posts: 2, Reputation: 1

New Member

Dec 22, 2008, 11:06 AM

System goes into aux heat

Replaced really and system goes int to aux heat

KC13 Posts: 2,556, Reputation: 99

Ultra Member

Dec 22, 2008, 01:09 PM

How cold is it there? Perhaps this is a good thing. Mine is using auxiliary heat and I didn't replace any relays.

Add your answer here.

Check out some similar questions!

What kind of heat and AC system do I have [ 2 Answers ]

How do I find out if I have 2 stage heat 1 stage Aor any other kind of combination there is

More Heat from Hot air system [ 4 Answers ]

I have a forced hot air heating system. House is a small cape. About 1500 SF living area. I. use about 550 Gallons of heating oil in a season. With oil at $4.50 per gal.I want to try to squeeze more efficiency out of the system. Furnace is 24 years old. I know the new burners have a pre and post...

NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue. [ 11 Answers ]

I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -

System calling for heat but no response from system [ 1 Answers ]

My thermostat is set to 25 which is higher than the current temperature but my heating system is not firing up.. we have hot water - the boiler is a Micron - the heating timer is set to "on" on the program setting, and so is hot water which is fine but we have no heating, it was on earlier and went...

5 Wire 24v AC/Heat System [ 3 Answers ]

Hi, I bought a home. Had no thermostat. Putting in Honeywell CT3500 Programmable. Have Red, Green, Yellow, Blue, White. AC works but no heat. Thermostat came with R jumpered to Rc. How do I wire this to get AC and heat? Thank you. I need to also explain that I did put the appropriate wires...