Ask Experts Questions for FREE Help !
Ask
    Johnnygets's Avatar
    Johnnygets Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 11, 2008, 09:40 AM
    Rotor postioning on 95 Acura integra
    OK my car broke down at work I replace the cap an rotor. It ran once again but it was misfiring then about of two miles later it shuts off again. The screw on the rotor is missing is this the problem. Or is it the position of the rotor or that I did not disconnect the battery to reset whatever?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Dec 11, 2008, 10:04 AM

    You definitely need to replace the rotor's mounting screw or you will destroy the rotor and the distributor cap. It would not surprise me if the problems you are experiencing are related to the Ignition Control Module and/or the coil failing. Here's how to replace them yourself:

    https://www.askmehelpdesk.com/cars-t...tml#post265896

    Once you replace all of these components, disconnect the negative battery cable for 10 seconds, in order to reset the ECM.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1991 acura integra [ 4 Answers ]

Hi I have another question for you. I have a 1991 Acura Integra with a idling problem. I've check the vacuum lines they were all good and I've also change my idle air control valve three times to make sure that wasn't the problem. I put another engine in the car but the person I bought the car off...

94 integra no spark after replacing cap & rotor [ 3 Answers ]

Replaced cap and rotor car started afterwards then died after 10 sec now I have no spark. Put old cap and rotor on still nothing. I have power coming out of the coil, I think the ignitor is bad but not sure also I don't here the injectors clicking when trying to turn over car, but I am not sure if...

1991 Acura Integra [ 4 Answers ]

Hello all My nephew has a 1991 Acura Integra. My parents have replaced the engine, the distributor, wiper motor. When attempting to start the car and it runs through its checks IF the engine light stays on it won't start. You have to "feather" the accelerator to get it to 2000 rpms before it...

View more questions Search