Ask Experts Questions for FREE Help !
Ask
    cs18ig's Avatar
    cs18ig Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 14, 2008, 03:32 PM
    94 integra no spark after replacing cap & rotor
    Replaced cap and rotor car started afterwards then died after 10 sec now I have no spark. Put old cap and rotor on still nothing. I have power coming out of the coil, I think the ignitor is bad but not sure also I don't here the injectors clicking when trying to turn over car, but I am not sure if this is controlled by the ingiter. It is a honda b18b1 engine please help
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Nov 14, 2008, 03:44 PM

    Yes, replace the ignitor and coil. I recommend replacing both of these problematic components after 120,000 miles or 10 years, whichever comes first.

    If you prefer, perform all tests listed in Sections A and B of the Sticky.
    cs18ig's Avatar
    cs18ig Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Nov 14, 2008, 04:54 PM
    Does the igniter control the fuel injectors
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #4

    Nov 14, 2008, 06:38 PM

    No. Under direction of the ECM, the ICM controls when the coil fires.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

No spark, acura integra 95 non-vtec [ 3 Answers ]

I have been going crazy checking everything possible, when I try to start my car a check engine light comes on. It is code 15 which is ignition output signal. The engine cranks and the fuel pump primes. I checked my coil for resistance and voltage and it passed. I tested the ICM (igniter) for...

12.5 briggs and s that lost spark magnito replaced and no spark [ 3 Answers ]

I have a Deutz-Allis 613 lawn tractor with a B/S 12.5 horizontal engine. When I got it. The engine would run fine unless it was under a load... if the choke was pulled out half way the engine wouldn't stall. I replaced the drive belt and then the mower belt sharpened the blades and the tractor...

96 integra power to icm but no spark to motor [ 3 Answers ]

Hello everyone, Stuck with this problem please help. No spark to the motor new distributor, wires and plugs found alarm wire loose could this be the cause?

Honda Integra no spark Broken I desperately Need Help [ 4 Answers ]

My 1993 si/gsr 1800cc vtec integra won't start, I had I running for around 20 minutes then all of a sudden it died and since then has not restarted! It had been sat outside for around 5- 6 months! It cranks with no spark! Ok I have done the following things 1. checked fuel pump - good 2....

Replacing Spark plugs [ 7 Answers ]

Hi I hve a 1995 BMW 525I and planning to replace the sprk plugs need to know if I have to use some kind of lubrecant on the sprk plug threads and what will be the torque value, Thanks.

View more questions Search