Ask Experts Questions for FREE Help !
Ask
    OakwoodProp's Avatar
    OakwoodProp Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 30, 2008, 06:43 PM
    Intertherm furnace diagnostics code
    I have an Intertherm Furnace in a mobile home that I own and rent out. The furnace has a self diagnostic capability and shuts down periondically. The indicator lamp(red light) flashes in a series of four (4) flashes after it has shut down. I can reset it very easily by turning off and back on the power. It will run for several days and then do the same thing. I have already changed the filter to a free flow filter. My Question is what does the 4 flashes indicate? Thank you in advance.


    I have looked all over for this information and cannot find it any where on or inside any furnace component. Thanks again.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Nov 30, 2008, 11:24 PM
    Post your question here under Nordyne. These folks have a great board for mobile home furnaces and they also have the parts available if you need them.


    mobilehomerepair.com :: Index
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My intertherm furnace pilot lights but furnace won't kick on [ 5 Answers ]

I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...

Intertherm Funace diagnostics code [ 1 Answers ]

I have an Intertherm Furnace in a mobile home that I own and rent out. The furnace has a self diagnostic capability and shuts down periondically. The indicator lamp(red light) flashes in a series of four (4) flashes after it has shut down. I can reset it very easily by turning off and back on...

Intertherm Furnace [ 4 Answers ]

My furnace Intertherm Model # MHHB-077ABHR-06 just starteed kicking the blower in and out. The blower will run for 30 seconds, then stop, about 10 seconds later, it'll kick in again. Sometimes this will go on for 15 minutes. The flame is kicking in and it has electronic ignition.

Intertherm Furnace [ 2 Answers ]

I have an Intertherm Furnace model MGHA-077ABFC-05. The pilot continuously goes out on it. Is there another filter or something other than what is on the furnace door ?

Intertherm furnace [ 2 Answers ]

I have just in the last month had an Intertherm furnace installed, and since installation they have had to come in twice because they claim the starter button is not firing. They replaced it and now it is on the fritz again. It starts for about 8 seconds and cuts out. There is fuel in the tank....

View more questions Search