Ask Experts Questions for FREE Help !
Ask
    tjmothy's Avatar
    tjmothy Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 7, 2008, 05:52 PM
    Dyer has no heat
    I have a roper dyer does anyone know why it has no heat it still spins a complete cycle
    Flying Blue Eagle's Avatar
    Flying Blue Eagle Posts: 2,056, Reputation: 225
    Ultra Member
    		  
    #2

    Nov 7, 2008, 09:39 PM

    Tjmothy - There is several different reasons you don't have heat on the dryer
    #1- check to see if you have 220 volts to the dryer, if you don't have a VOLT -OHM meter that will read 220volts, Go to Lowe's OR HOME DEPOT <SEARS< ELECTRICAL SUPPLY AND GET ONE BUT MAKE SURE IT WILL READ THAT HIGH VOLTAGE , CHECK , At the receptical to see if there is 220 comeing to the receptical, ( NOTE) The dryer will run on 110 volts but will not have the power for heater coils to work::
    Tjmothy- Go to post by (Isjpunk) & posts below you There are three different posts on this same reason ,I have posted on them the probabsale cause and how to do the testing with a volt-ohm meter and what is good readings and bad readings . You will probably find your trouble at the heating coil. Let me know if you need any further help with your problem ;; Have a good day and remember that you are messing with 220 and it is NOT FORGIVEING< STAY SAFE , GOD BLESS::: F.B.E.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Whirlpool imperial dyer will not heat up [ 1 Answers ]

Cleaned vents and inside and the dyer was working yesterday and is not now . It is a gas dyer

Venting gas dyer [ 1 Answers ]

Can I vent my gas dryer into the garage?

Kenmore dyer with no heat [ 1 Answers ]

I have a kenmore dyer series 110 Serial #ms4002505 Runnning but io have no heat Circuit breaker checked and is okay.. lint removed... is it possible I need a new heating element as I have had it approimately 2years Tks [email protected]

Gas dyer problem [ 1 Answers ]

-------------------------------------------------------------------------------- Hi I am an HVAC tech an having problems with my Frigidaire gas dyer M#GLGR331AS2, S#XD31100005. Here it goes, it runs for about 5 to 10 minutes. Then cycles off, the flame. When it goes to relite the HSI warms up...

Dyer Not Drying [ 3 Answers ]

I put the hose to the dryer and the other end that is attached to the house. I made sure it was secure. Once today the dryer was not even warm and I checked that hose and it had popped off. I replaced it. Now my close are drying, but at a slow rate and the hand dial thing is not moving closer to...

View more questions Search