Ask Experts Questions for FREE Help !
Ask
    lessiembre's Avatar
    lessiembre Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 13, 2006, 08:46 AM
    Kenmore dyer with no heat
    I have a kenmore dyer series 110
    Serial #ms4002505
    Runnning but io have no heat
    Circuit breaker checked and is okay.. lint removed... is it possible I need a new heating element as I have had it approimately 2years

    Tks
    [email protected]
    andrewcocke's Avatar
    andrewcocke Posts: 439, Reputation: 22
    Full Member
    		  
    #2

    Dec 13, 2006, 03:49 PM
    You will need to check the element, its possible that it burned out.

    Feel behind the dryer while its running, around where the element is at, it should be getting hot, if it isn't getting hot, then test the element for voltage across the two leads of the element. (where the wires hook to), if you read 220-240 volts here, and its not heating, then your element is bad.

    An additional check is to check the lint duct, through the wall, and under the drum where the blower is at, many times that gets clogged and causes inefficient heating.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore Elite Dryer won't heat [ 16 Answers ]

I have a heavy duty Kenmore Elite dryer for about 5 years (bought new) but it doesn't heat now. Power works fine. The inside part turns/tumbles fine. Light works when you open the door. We clean lint out each time. Just doesn't heat on any of the dial settings. I've switched power at the...

Kenmore dryer help / No heat [ 2 Answers ]

I have a Kenmore 80 series Super capacity plus dryer. Model# 77832791 77832 that is not heating. Sounds like after it runs for about 30 seconds that it is trying to fire up but then doesn't. I consider myself to be handy and could probably fix it with some help. Any idea where I should start? Does...

Kenmore dishwasher won't heat water [ 3 Answers ]

I have a new Kenmore Elite dishwasher. I have checked the water during the Hi Temp wash cycle and the sani rinse cycle and it isn't any hotter than 133 degrees, the temp of the water from my water heater. The instructions say the water should be at a minimum of 129 from the tap and I always run the...

Kenmore Dryer won't heat (most of the time) [ 2 Answers ]

I have a Kenmore Evenheat dryer that no longer dries my clothes consistently . I took off the front panel, and what I observe it that when I start it up, there are three different possible outcomes: 1) The heating element glows red, and 5 seconds later the flame ignites and the dryer works...

Kenmore dryer runs but does not heat [ 3 Answers ]

My Kenmore dryer just stopped heating but it runs. The model number no is 110.62994101. I need help on how to fix it. If possible with diagram on How to change any part.

View more questions Search