 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Start by removing the drive belt between the deck and the engine. Lower the unit an inspect the route of the belt. It goes around each blade arbor, around the drive pulley, an idler and the moveable pulley that engages the blades. The idler and moveable pulley is spring loaded and can be pulled back to give you room to peel the belt off one pulley. There are keeper pins around the blade pulley to keep the belt from jumping, tight but you can peel/roll the belt past the keeper.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I need to replace my deck belt on troybilt 17hr. 42' riding lawnmover. Be nice to have a diagram
I have a craftsman 38" cut mower that is probably 10 years old with a 14 hp motor. I cannot figure out the configuration of the mower belt installation. Can you help? Thanks, Skip
Does anyone have a picture that they shows how the belt is routed on the deck for an MTD 16/46 model number 130675H302? The belt broke and I need to replace it. Thank you
I have a problem changing the deck belt on a troy -bilt ridding lawn mower model n779 pony. There is a guard on the deck idler pulley that will not allow me to put the belt on on the pulley.what would be the solution,what am I doing wrong?
Hi. I have got a problem with the deck belt on MTD Model 14AS84AH062. I have a new replacement belt but the problem is, I did'nt see how it was before it broke. At the end of the one side there is a thing that has a thin cable running from it, and I can't seem to understand were that has to...
View more questions Search
|
