Ask Experts Questions for FREE Help !
Ask
    sham823's Avatar
    sham823 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 24, 2007, 09:06 PM
    Mower deck belt configuration
    I have a craftsman 38" cut mower that is probably 10 years old with a 14 hp motor.
    I cannot figure out the configuration of the mower belt installation. Can you help?
    Thanks,
    Skip
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
    		  
    #2

    Oct 27, 2007, 06:35 AM
    Go to sears.com and look up your model #'s diagram and it will show you a picture.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I need to replace my deck belt on my troybilt 17hr. 42' deck belt diagram [ 4 Answers ]

I need to replace my deck belt on troybilt 17hr. 42' riding lawnmover. Be nice to have a diagram

MTD 42" mower deck belt [ 2 Answers ]

I'm trying to put a deck belt on a 42" MTD, 14.5 hp. All the numbers on the labels are worn off so I cannot get an owners manual or schematic. We have dropped the deck down and have gotten the belt on 2 pulleys, (there are 3) but it appears short and will not go on the other pulley. I took the...

Mower deck belt loose [ 3 Answers ]

Please help I have JD 60" med mount mower deck I can't keep the drive belt on I place new belt on and same problem any way to adjust the belt?

Belt routing on mower deck [ 1 Answers ]

I have a Troybuilt 46 inch, 22 h.p. mulcher GT, petal drive with cruise control. The long belt on the mower deck continues to break. I need a diagram of belt routing and also location of spring on tension pulley. This belt is 98", but I have been using a 96" A belt because it is wider and thought...

Deck belt for craftsman 15.5 riding mower [ 1 Answers ]

I have a 8yr old craftsman riding mower with a 42in deck I went to get a belt and I got the right one but I can not get it to go on do I need to remove any of the pullys or are there any tricks that I need to know or should it just go right on it is about 3inches to small. And I did disengage the...

View more questions Search