Ask Experts Questions for FREE Help !
Ask
    jbell's Avatar
    jbell Posts: 9, Reputation: 1
    New Member
    		  
    #1

    Mar 28, 2008, 11:05 AM
    Replacing gas lines to weedeater
    I need to know how to replace gas lines to a craftsman weedeater mod# 358798470 or a website with diagram and instructions.
    Thanks
    Jim
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
    		  
    #2

    Mar 28, 2008, 04:13 PM
    Well, cut the end going into the tank at an angle of about 60 degrees and you may need some forceps to pull the line up out of the filler neck to cut off straight, then add the weighted fuel filter.
    You can try,
    Sears.com
    Have your model number handy, and sometimes the serial number is needed.
    jbell's Avatar
    jbell Posts: 9, Reputation: 1
    New Member
    		  
    #3

    Mar 29, 2008, 07:04 AM
    Quote Originally Posted by MOWERMAN2468
    well, cut the end going into the tank at an angle of about 60 degrees and you may need some forceps to pull the line up out of the filler neck to cut off straight, then add the weighted fuel filter.
    you can try,
    sears.com
    have your model number handy, and sometimes the serial number is needed.

    Thank you.. I have gotton that far but There are two line connections on the carburator and two connections on the primer bulb. I need to know how this chinese puzzle is supposed to be hooked up. What goes where?
    Thanks
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #4

    Mar 29, 2008, 10:20 AM
    MM gave you the wrong URL. It's www3.sears.com. They usually have exploded diagrams for just about anything.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Weedeater blower starving for gas [ 5 Answers ]

I have a weedeater brand that will run when I pour gas into the carburetor and will sometimes run a little on choke. When I try to open it up it dies. I don't think it is getting enough gas. I took the carb apart and cleaned it and it helped.

Weedeater fuel lines tube length [ 2 Answers ]

How long should the two fuel lines be. I received a kit with extra length lines?

Replacing two supply lines with one [ 4 Answers ]

Where can I find a table showing flow volume for water pipe? I'm replacing two iron 3/4" pipes with a single line - a second floor bath & I"m replacing the hot/cold with just a cold supply then splitting and doing a point of use water heater.

WEEDEATER xt 40t model gas [ 2 Answers ]

I just got this trimmer today from work , it will start almost all the time but when it does, the idle is very rough, it'll go up and down really fast. Please help thanks Chad

Maytag gas dryer, replacing gas valve coils [ 5 Answers ]

Hi, I hope someone can help me. My Maytag gas dryer's igniter glows but then no flame appears. I believe it is the gas valve coils that are bad, so I purchased a replacement kit (3 coils). The instructions say to match the colors of the wires, but my replacement kit has red, black, white...

View more questions Search