Ask Experts Questions for FREE Help !
Ask
    bjjones's Avatar
    bjjones Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 5, 2008, 02:27 PM
    Amana furnace installation
    Amana furnace that was installed in my house used 2" pvc for the exhaust. i was told by a technician that was out for a repair that it should have been vented with 3" pvc. Model#gvva070ax40
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
    		  
    #2

    Feb 5, 2008, 04:55 PM
    How long and how many elbows. If you have the manuals, the install manual will tell you what sives, lengths and elbows allowable. I do see this problem quite a often.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Amana furnace [ 2 Answers ]

Hi Everyone, I am having so much trouble, trouble shooting my furnace, I have a Amana Furnace, I noticed that the Burner is not staying long enough for the heat to blow through the vent. This is my observation, once adjusted the temp desired in the thermostat, the burner on the furnace...

Amana furnace [ 2 Answers ]

I misplace the wiring diagram and installation manual for my Amana Furnace. Any chance someone, website may have a good source for that: Mod # GUCO70B40A, Serial # 9110104173, Mfg # P9114303F Suggestions for a fix would be appreciated also: Having problems starting. The igniter works fine...

Amana gas furnace [ 1 Answers ]

Where can I find a natural to lp converter for amana furnace

I have an Amana 80+ furnace. [ 1 Answers ]

When the temperature reaches the desired setting, the gas burners turn off as they should, however the fan continues to run and blows cold air. The temperature dips well below the thermostat setting, but the burners do not turn back on and the fan continues to run. I also notice a flashing red...

View more questions Search