Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Blower during furnace operation on electric Coleman Evcon
[ 2 Answers ]
I just installed a programmable thermostat for an electric Coleman Evcon furnace. Now when the furnace comes on the blower also comes on. Sometimes the blower goes off a minute or so before the furnace stops. It never did this before- in fact I didn't even know there was a blower. Do I need to...
Electric Furnace
[ 5 Answers ]
My electric furnace will work perodically, I'm not sure of the brand or model, it's in a 1986 doublewide. It will run and heat fine for a few days, and then it will just stop for a day or so, then start again. Inside the furnace panel I can hit the rocker switch to the ON position, instead of AUTO...
How to convert a gas furnace to electric furnace
[ 1 Answers ]
Is there a conversion kit
Electric Furnace
[ 1 Answers ]
Can a sequencer have a short in it that would cause the blower (on auto)to work intermittingly?It wouldn't work on auto for a week then it worked for a few days and now it won't.?
Lennox electric furnace, blower off alignment, rubbing housing
[ 1 Answers ]
Excuse my lack of mechanical knowledge and I hope I can explain the problem in an understandable way. The blower on the electric furnace has gotten out of alignment(?) and is rubbing the housing(?). I can put it in the correct position so it does not rub by physically holding the shaft but cannot... View more questions Search
|