Ask Experts Questions for FREE Help !
Ask
    kiethy's Avatar
    kiethy Posts: 3, Reputation: 1
    New Member
     
    #1

    Jan 10, 2008, 07:52 PM
    Mtd bolens hotwired part 2
    OK had a good look at coil and found a tang that obviously was meant to have a wire, so I solded one on. My understanding is that when this wire grounds it will kill the motor, so it should go to a switch and then to ground. Other mtd's seem to ground it first and then off to other safety switches... how does that work?
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
     
    #2

    Jan 12, 2008, 06:47 AM
    With the use of an insulated connection block.
    kiethy's Avatar
    kiethy Posts: 3, Reputation: 1
    New Member
     
    #3

    Jan 14, 2008, 01:35 PM
    OK, so is it not really going to ground? I have run it to a switch and then to ground, any probs with that setup? It is working,

    Thanks for reply

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Mtd Bolens hotwired won't stop [ 1 Answers ]

Friend gave me a 94 bolens mtd with 12.5hp briggs. He obviously had key problems and removed the ignition (bypassing most of wiring loom) and ran a push switch for starting between small wire from solenoid and battery. The coil is new and has no wires to it, how can I make a kill switch without at...

Bolens 15.5 38 in cut 6 speed on the fly [ 1 Answers ]

Whole unit jerks at times when blades are engaged. Any answers?

Bolens Mower - Key Won't Go In [ 2 Answers ]

I have a Bolens Riding Mower model 2136. It would not shut off, and I had to pull a spark plug wire to get it to shut off. I took out the key while it was still running, and now I can't get the key to fit back in. Any suggestions as to: 1) Why it wouldn't shut off; 2) Why the key won't...


View more questions Search