Ask Experts Questions for FREE Help !
Ask
    vglen54's Avatar
    vglen54 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 9, 2007, 07:45 PM
    Goodman furnace will not lite
    My Goodman GMP series furnace will not lite. The inginiter glows but the burners will not lite. I am not getting the 24V to the gas valve. I can put 24V to it and all will work until the next time the thermostat call for heat and again the inginter will lite but the burners will not. You can hear the relays operating on the circuit board but I still do not get the 24V to the gas valve.
    nekich's Avatar
    nekich Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Dec 11, 2007, 04:50 AM
    Having similar problem with our goodman. If you get an answer can you email me please? Thanks! Jeff

    [email protected]
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Gas Furnace will not lite [ 6 Answers ]

I have a 20 year old Rheem Gas Furnace with a standing pilot light. When I lite the pilot this season, everything worked fine. Furnace Fired up and all was good. Replace the panel, and by the time I took A few steps from the furnace it shut down. Now it will not relite. I have Jumped the...

Furnace won't lite [ 1 Answers ]

I have a amana furnace can't get the hot surface igniter to work... igniter is new, no power to it.. control board flashes once , meaning a lockout(?)furnace will light if I use lighter... I checked all 3 overloads and pressure switch, all show good... induction fan runs as soon as power is on,...

Bryant furnace won't lite [ 3 Answers ]

Hello, I have a Bryant furnace. It Keeps flashing code 13 on the circuit board. I read the code and it says that the switch will reset after 3 hours. It also refers me to # 33 which gives more possibilities as to what the problem may be. However it does say to reset the limit or flame roll out...

HEIL furnace will not stay lite [ 3 Answers ]

I have a older heil furnace (Model#867.769445) about 20 years old. When the pilot turns on after a few seconds the burners light, then after a second or two they shut off, on again, and off. They will do this continually until finally they stay on or the furnace stops trying to heat. I have also...

Gas Furnace Doesn't Lite [ 3 Answers ]

My Carrier Furnace Igniter glows but the valve won't turn the gas on. I have discovered that the relay switch on the top of the valve has a bad connection to the pins (2 each) on the two solenoids. I can loosen this and slide up and down several times and it will work for awhile. My problem is that...

View more questions Search