 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Bryant Furnace Burner Malfunction
Hi,
We have a 19 year old Bryant gas furnace with a hot surface pilot igniter. The problem is that the pilot lights when the thermostat calls for heat, and then lights the burners which shut down after 15 to20 seconds. It then relights and continues this cycle ten or twelve times before the will start. It seems to me that a sensor must be opening and closing the gas valve. Does anyone have any ideas? Thank You, Lakewood |
||||
|
||||
|
Not an expert in this field so stick around for the pros
Mine did the same... would cycle on and off... furnace seemed to think the gas wasn't being burned in a flame so itd shut off and recycle through the program again... Cleaned the flame sensor with some fine sandpaper to see if it was just some corrosion/grime and it seemed to do the job. Expected to have to replace it but so far its worked just fine... |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
After the furnace heats to the desired setting of the thermostat the gas flow to the burner stops and starts every few seconds with the igniter also starting and stopping. Igniter is 2yrs. Old and won't last long operating like this.
I have an old (14 years ?) York Stellar furnace that used to have this problem sometimes. When the gas was released over the red glowing electric igniter, it would ignite with a more or less loud pop that would also kill the flames. Then it would go again through the whole sequence and everything...
Bryant Gas Furnace P/N 394DAC03100 about 30 yrs old. Pilot light stays light and burner going on and off after checking valve problem seems to be some type limit switch when I move the wiring by shaking a little it ignites. Having a problem finding which wires are loosely connected..? If anyone...
Why would my furnace kick off and say limited cycle on the code ?on a coleman evcon
I have a valve on a Bryant Burner for an old gas furnace. There seems to be a problem with the gas valve that feeds the burner. Are 40 year old valves available? Thank you. Dennis
View more questions Search
|
