Ask Experts Questions for FREE Help !
Ask
    dwlittler's Avatar
    dwlittler Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 26, 2007, 11:50 AM
    Multiple fluorescent lighting wiring
    How do I wire in several fluorescent light fixtures off one light switch?
    Thanks
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #2

    Nov 26, 2007, 02:49 PM
    One simple way is to feed the switch with a two wire cable, then continue from the switch onto the first light then to each light thereafter , light after light, etc.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #3

    Nov 26, 2007, 05:29 PM
    If somehow you have cords and plugs already installed on them, you could go from switch to center of 4 lights, and install a 4X4" Box, a Quad Receptacle cover and recepticles. You will need another quad setup for each set of 4 lites.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Leviton PR180 with fluorescent lighting [ 14 Answers ]

Hi everyone, This is my first question on the forum so here goes... A while back I installed a Leviton PR180 Motion Detector Light Switch in my laundry room and it worked beautifully. Earlier today I installed a 2-bulb fluorescent fixture in place of the incandescent fixture and this is...

Fluorescent & Low voltage lighting on same switch [ 1 Answers ]

Is it okay to have fluorescent light fixtures (4ft tubes) and 12v low voltage lighting on the same light switch? Thank you

Q's About Compact Fluorescent Recess Lighting [ 9 Answers ]

I have a couple q's about some of the compact fluorescent recess lights I've been looking at from Halo. I'm planing out some lighting for the front of my garage and I will be using these in the soffits in front of the garage door for accent lighting/wall wash. I'm curious what the difference is...

Wiring multiple receptacles [ 1 Answers ]

I have already run my sub panel and you would think I would remember how to wiring multiple receptacles. But I don't! Ok, here is what I am trying to do. I have a 20 amp circuit and I am connecting 6 receptacles on this one circuit. The first circuit is connected to the breaker (easy) but I...

Flickering fluorescent tube lighting [ 3 Answers ]

Hi. I have the long fluorescent lighting fictures in my den (2 long fluorescent bulbs per ficture). One of the fictures (both bulbs) are flickering... more like they are half on than flickering, kind of give off a grayish appearance. I put in 2 new bulbs but got the same issue. I installed a new...

View more questions Search