Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How to wire a 2 speed Century AO Smith 1 HP spa pump
[ 10 Answers ]
It is a BN81 1725/3250 with L1, L2, A, B white and brown wire connections. I get it to run on white on L2, Black on B, but I cannot get low speed to run. What is correct connection for my white, red, and black wires to go to my controller? Thanks
Coast spa only high speed on pump 2
[ 1 Answers ]
I have this problem with pump 2 not going on low speed and the fiber optic lights not working.Had this happen before and I had a hot tub tech come, from the display panel he a justed the setting and everything worked fine. The kids have messed up the setting because now I have the same problem....
Spa Pump & Air Switch wiring
[ 3 Answers ]
Have a new 230 volt 2 speed pump on a T104 clock with a Len Gordon 3F-95 Air Switch and a 230 volt heater. Need a wiring diagram from the panel to the clock to the switch and to the pump and heater. Pump has Common; Low & Hi connections and Air Switch has Line 1; Line 2; Load 1A High and Load 1B...
Spa pump fuse
[ 1 Answers ]
The PUMP 1 FUSE light is on and the pump doesn't work. The control system is a CS6230VDS from Hydro Spa. I assume I should change the fuse but I can't tell where it is. Can anyone help me?
No 240 volts to spa pump
[ 5 Answers ]
Hi, I really hope someone can help with this, I recently replaced the pump on my spa, it is a 240volt 2 speed pump as was the original. It ran for about 4 hours then stopped, the time delay fuse (20a) on the circuit board had blown so I replaced that and now nothing runs except the light, and I... View more questions Search
|