Ask Experts Questions for FREE Help !
Ask
    jacoby99's Avatar
    jacoby99 Posts: 1, Reputation: 1
    New Member
     
    #1

    May 8, 2012, 12:38 PM
    How do I prime utilitech pump
    How do I prime utilitech pump
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    May 8, 2012, 12:51 PM
    Quote Originally Posted by jacoby99 View Post
    how do i prime utilitech pump
    There should be a threaded opening on top of the impeller housing. This opening may have a gage or a plug in it. Shut the pump off and remove the fitting. Fill the impeller housing until it overflows. Replace the fitting and start the pump. Everything OK now? Good luck, Tom PS. What's with the females? If you're selling them I'll take two.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How do you adjust the pressure switch on a Utilitech 3/4hp Jet Pump? [ 6 Answers ]

I think I messed up the standard adjustment of the Utilitech Pump which is set at 20/40 from the factory. Now I can't get the pump to stay on since I adjusted it? Curious if anyone knew any tricks?

Pump lost prime and overheated motor runs but does not pump is the pump fried [ 4 Answers ]

Over night the pump lost primed and melted the sched. 40 fittings I replaced all the fittings and cannot get pump to prime the motor runs is it possible that the propeller was damaged from the heat?//

How to prime the pump for a well that serves a geothermac heat pump [ 0 Answers ]

The power went off for a while this afternoon. When it came back on... the pump had lost it's prime... how do I prime the work to get my air conditioning on again?

Water well pump won't prime I know but I can't get to prime [ 0 Answers ]

I know how to prime a water well pump but Icant get it to prime . How would I know if something wrong with the pump


View more questions Search