 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Bryant condensing gas furnace noise
I Have A Bryant Model 350mav Condensing Gas Furnace That Is Very Loud At Start Up. The Sequence Of Operation Is That An Inducer Moter Runs For A Prepurge Period Previous To The Ignition Sequence. It Is This Period That A Lot Of Noise And Vibration Takes Place. After Ignition And The Blower Motor Comes On The Furnace Quiets Down. Should I Just Replace The Inducer Motor Or Could There Be Another Cause For This Noise And Vibration? Has Anyone Had Experience With This Furnace And Inducer Motor Noise?
|
||||
Check out some similar questions!
Hi All, I have a 5 y/o 80% eff bryant furnace. The problem I have is that my furnace Doesn't always kick on even when thew thermostat shows the temp under the Temp set. I will sometimes have to go down and turn of the blower switch on the furnace wait a couple seconds and then turn it on again....
I purchased a new Bryant 2 Stage furnace last year and it now makes a rumbling / vibration noise when the furnace kicks into the second stage. It seems like it does this when the furnace gets a lot of use. For instance, Today it turned on once or twice and no rumbling/vibration noise. However,...
Hello, I have a Bryant furnace. It Keeps flashing code 13 on the circuit board. I read the code and it says that the switch will reset after 3 hours. It also refers me to # 33 which gives more possibilities as to what the problem may be. However it does say to reset the limit or flame roll out...
How do you adjust pilot light?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
