Ask Experts Questions for FREE Help !
Ask
    quickwillie's Avatar
    quickwillie Posts: 18, Reputation: 1
    New Member
    		  
    #1

    Oct 9, 2009, 06:10 PM
    Golfcart switch
    I purchased a Hyundai golf cart. Someone has unwired the key switch , it has 4 wires red/black/brown/black&red. There's some letters E &M and the #'s 1&2 on the back of the switch. Unable to find anything on how to wire it. Any suggestions
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Oct 9, 2009, 07:32 PM

    Is this a fwd/rev switch with a center off position or for the headlights?
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #3

    Oct 9, 2009, 07:47 PM

    Hi,
    Never worked on one but here is your schematic (not easy to find):
    Peace,
    Clarke
    Attached Images
     
    quickwillie's Avatar
    quickwillie Posts: 18, Reputation: 1
    New Member
    		  
    #4

    Oct 10, 2009, 04:22 PM
    Quote Originally Posted by KeepItSimpleStupid View Post
    Is this a fwd/rev switch with a center off position or for the headlights?
    It's the on/off switch
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #5

    Oct 10, 2009, 05:42 PM

    I had no luck finding wiring for the 4 wires to the 4 terminals.
    Can be figured out. Need to Know:
    How many positoins? On/Off/Acessory?
    What connections are made between the terminals for each switch position.
    Where the 4 wires are from, 1 should have 12 volts(constant hot). Is this gas? M may be to ground mag.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replacing fan motor relay switch with upgraded switch [ 4 Answers ]

Hello, I've searched online to locate a replacement fan motor relay switch for an old Fedders propane heating unit in my greenhouse. The replacement should be fairly easy to do, however the part I was needing ( RBM 84-20103-301A) was listed as obsolete and was replaced by (McQuay part #...

Switch/Circuit board switch trips with Dehumidifier in basement [ 1 Answers ]

Hi, I have whirlpool gold dehumidifier of 40 pint, running in basement for last 4 years, all of sudden it stopped working, when I checked it tripped the circuit board switch. I tried re-setting switch and plugged in the dehumidifier, it runs for 3 seconds and again switch trips. I tried in...

Connect a port on a remote switch to a secure segment on the local switch [ 4 Answers ]

I have 2 Netvanta 1224R switches. On the main switch I have 3 Vlans setup. Vlan1 = main network (example IP 123.231.5.1) Vlan2 = Web Access (Example IP 69.115.851.202) Vlan3 = Secure segment (Example IP 123.231.8.1) On the remote switch I have 1 Vlan. Vlan1 = Main network (example IP...

HEAT-OFF-COOL system switch - AUTO-ON fan switch. [ 2 Answers ]

Dear Gurus, I am a new house owner & not used to thermostats. We have Honeywell 8112D thermostat. We recently turned ON our Fan switch (in the thermostat). Now the fan is not turning off. It is continuously running even when the system is in OFF & Fan is in AUTO mode. We tried reducing the...

Converting pull switch lights to wall switch [ 3 Answers ]

I've been struggling finding the answer to this in books and online, it seems as if it should be an easy question and something that gets done all the time. Looking for some help. My basement has several rooms and all lights are wired "hot" with pull switches from each light receptacle. When the...

View more questions Search