Ask Experts Questions for FREE Help !
Ask
    kevin25's Avatar
    kevin25 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 9, 2008, 06:53 PM
    97 dodge brakes won't work
    Hi replaced brakes on truck both front calibers ,pads,lines -now can't get fluied to calibers -blead 4- 2 hours still nothing - no fluied to brakes at all ont even in lines to brakes help please
    mr wendal's Avatar
    mr wendal Posts: 13, Reputation: 2
    New Member
    		  
    #2

    Feb 9, 2008, 09:53 PM
    Try bleeding the master cylinder first, before you attempt to get the air out off the lines going to the calipers, you definitely have air in the lines. Also a good thing to try is to loose the bleed screw on the calipers and get about a full turn on each one , full the master cylinder and then leave it for a while , gravity will take it's cousre and as the fluid comes down the majority of the air woul've been displace . Hope this helps
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Saturn won't start, power locks won't work, radio resets itself. [ 4 Answers ]

My 99 Saturn has had some starting problems in the past. It would sometimes not start but if you let it sit from anywhere from 45 minutes to 24 hours, it would eventually start. Or, after having Dad look at it, we could tap the starter and it would work. So we thought it was the starter. I...

Why won't my troy bilt riding mower not stop even when the brakes are pushed? [ 1 Answers ]

I have a riding mower that was made in 2000. It will run but won't stop when the brakes are pushed. What could be the problem. This system is way different than my craftsman!

Kenmore he4 panel won't work and dryer won't start [ 1 Answers ]

I have had the circuit board/panel replaced once on my he4. I had only 2 weeks left on the warranty and figured it should be OK once it was fixed. They wanted another $200 to renew the warranty! Didn't have the $$ at the time. Anyway, the same darn thing is happening... you have to push the buttons...

Murray rear engine mower, brakes don't work? [ 1 Answers ]

The clutch works as it should when you depress the brake/clutch pedal, but the brakes don't work. This is my first riding mower and need to know how to repair. Any help would be greatly appreciated. Thanks,

Brakes 1999 dodge intrepid [ 1 Answers ]

Hi I have a1999 dodge intrepid my brake lights work except for the third light the brake light on the on the trunk. I have no power coming to the light bulb sockets any help would be appreciated

View more questions Search