Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How to wire a Leviton PR180
[ 27 Answers ]
Hello, I purchased the Leviton PR180 to wire into a 3-way switch installation. My setup is exactly like the wiring diagram in the instructions, but I cannot get the #1 switch (original 3 way switch) to turn the lights on after the motion detector has timed out and turned off the lights. I...
Leviton PR180 with fluorescent lighting
[ 14 Answers ]
Hi everyone, This is my first question on the forum so here goes... A while back I installed a Leviton PR180 Motion Detector Light Switch in my laundry room and it worked beautifully. Earlier today I installed a 2-bulb fluorescent fixture in place of the incandescent fixture and this is...
Levitron PR180 troubleshooting
[ 2 Answers ]
I'm struggling to get a Levitron PR180 3 way switch to power a fluorescent fixture. I seem to get better performance in the ON position vs. AUTO which is the motion sensor setting. Please help.
Leviton PR180 without switch
[ 2 Answers ]
I purchased the Leviton PR180 and I would like to know if I can install without the switch. Could you please send to me the diagram? Thanks in advance, Marcelo Tralhao
Levitron 3 Way Motion Sensor Wall Switch
[ 2 Answers ]
I have power coming in from the basement to the first floor 3 way switch with a 4 way switch on the second floor and a 3 way on the top floor. The 3 way on the third floor appears to go to the lights. The 4 way has two wires going down as travelers to the first floor and two wires as teavelers to... View more questions Search
|