Ask Experts Questions for FREE Help !
Ask
    DAVISJC626's Avatar
    DAVISJC626 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 22, 2007, 09:07 AM
    Levitron PR180 troubleshooting
    I'm struggling to get a Levitron PR180 3 way switch to power a fluorescent fixture. I seem to get better performance in the ON position vs. AUTO which is the motion sensor setting.

    Please help.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #2

    Dec 22, 2007, 09:14 AM
    If it works correctly with regular bulb, then unit probably OK. I seen others mention problem using flourescents, a relay would solve problem by providing direct connection, instead of electronic switching, Triac? But your unit is probably functioning correctly.
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #3

    Dec 22, 2007, 10:17 AM
    Is the switch grounded? The sensor needs a ground to operate properly.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to wire a Leviton PR180 [ 27 Answers ]

Hello, I purchased the Leviton PR180 to wire into a 3-way switch installation. My setup is exactly like the wiring diagram in the instructions, but I cannot get the #1 switch (original 3 way switch) to turn the lights on after the motion detector has timed out and turned off the lights. I...

Leviton PR180 with fluorescent lighting [ 14 Answers ]

Hi everyone, This is my first question on the forum so here goes... A while back I installed a Leviton PR180 Motion Detector Light Switch in my laundry room and it worked beautifully. Earlier today I installed a 2-bulb fluorescent fixture in place of the incandescent fixture and this is...

Leviton PR180 without switch [ 2 Answers ]

I purchased the Leviton PR180 and I would like to know if I can install without the switch. Could you please send to me the diagram? Thanks in advance, Marcelo Tralhao

Levitron 3 Way Motion Sensor Wall Switch [ 2 Answers ]

I have power coming in from the basement to the first floor 3 way switch with a 4 way switch on the second floor and a 3 way on the top floor. The 3 way on the third floor appears to go to the lights. The 4 way has two wires going down as travelers to the first floor and two wires as teavelers to...

Can you use 2, 3-way Leviton PR180 motion sensors together? [ 17 Answers ]

I am thinking of ventilating 2 separate bathrooms with one attic-mounted Panasonic inline fan. I wanted to install a timer in bathroom A and a timer in bathroom B to control the fan. Unfortunately, there is no such thing as a 3-way timer. The idea of using 2 timers in a parallel circuit crossed...

View more questions Search