Ask Experts Questions for FREE Help !
Ask
    sshorey's Avatar
    sshorey Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 13, 2007, 01:34 PM
    Bryant furnace does not come on
    We have central AC/Heating with separate Bryant heating and AC units that are controlled from the same thermostat in the house.

    When I turn the Heat ON and set Temp to way higher than current Temp, the light on the thermostat comes on but the heating unit does not go on... no sound of burners coming on or anything, no fan blowing... in fact if I turn the fan ON manually, it shuts off when I turn the Heat on and comes back on after I turn the Heat off.

    If I turn the AC on, the fan comes on, the Ac unit makes noises like it is on and doing something but the air blowing out of the vents is not cold... just room temp.

    Could someone help please with anything I can try on my own before calling the tech.

    Thanks.
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Oct 13, 2007, 08:26 PM
    Is it a dual fuel system. Heat pump with gas back up.
    sshorey's Avatar
    sshorey Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Oct 14, 2007, 02:27 PM
    No dual fuel system... gas furnace and electric AC unit.
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
    		  
    #4

    Oct 14, 2007, 07:05 PM
    See FAQ at top of page and try to better observe th sequence of operation. Let us know
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

New furnace [ 1 Answers ]

I had a friend come out and look at my furnace because I was having some a/c issues and prior to it getting hot I was having some heating issues. Well the result is that my motor went. The furnace is/was about 25+ years old. I now have to purchase a new furnace. Where do I start?And does this...

Rheem furnace [ 1 Answers ]

My Rheem furnace is showing a diagnostic red flashing light, flashing 3 times. I cannot locate the manual on the furnace. Does anyone know what the 3 time flashing red light means?

Bryant furnace starts then stops [ 3 Answers ]

My Bryant forced hot air furnace gets the signal to ignite, the pilot light and then the furnace lights but it goes out in a few seconds. This will happen over and over and then occasionally it might stay lit and warm the house. Any ideas of what this could be and how to fix it. Much...

Furnace troubles [ 2 Answers ]

Our furnace just started this a few days ago... when the heat kicks on the furnace will heat up but the blower will not blow... does anyone know what could be causing this... we are thinking maybe thermostat?? WHen we turn the fan on then the furnace works properly... as long as we have the fan...

Furnace does not stay on [ 2 Answers ]

Hi I have a 115,000btu goodman furnace and when I go to start it in attempt to run but the burner does not stay on. It sound like there is a lot of condersation inside the unit

View more questions Search