Ask Experts Questions for FREE Help !
Ask
    GhostnKitty's Avatar
    GhostnKitty Posts: 1, Reputation: 1
    New Member
     
    #1

    Oct 13, 2007, 07:33 PM
    Heating Basements
    I need to heat my basement due to how cold it gets in the winter..
    labman's Avatar
    labman Posts: 10,580, Reputation: 551
    Uber Member
     
    #2

    Oct 13, 2007, 08:01 PM
    If you have forced air, it is simple enough to chop a few holes in the ducts and add registers. Be sure and get ones you can close to control the heat.

    If the basement is cold, it may have cold air leaking in. Meticulously caulk between the plate and foundation, the plate and band joist, and the band joist and the floor. Also around any pipes and wires through the wall or ceiling. In some cases, cold air can flow down from the attic into the wall cavities, and then into the basement cooling your whole house. Going up in the attic and caulking there helps too. It also reduces warm moist air reaching the attic and causing condensation problem.

    You may want to look at furring out and insulating the basement walls. Once again, they are predicting sharply higher heating cost this winter. Caulk and insulation is a one time expense that saves in all the years ahead.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Heating system isn't heating.. Is there a pilot that needs lighting? [ 1 Answers ]

I am renting a home that is 50 years old. It has recently turn cool, low 30s. If I turn the heating/air switch to heat and 70 + degrees. All I get is cool air coming out of the air vents. Can someone tell me what things I should do before calling heating specialist?

GFCI requirements for basements [ 2 Answers ]

Hello... I am about to install a new circuit in my basement to provide receptacles for small appliances such as a TV and a sewing machine. I understand that GFCI protection is required for "unfinished" spaces. 1. Exactly how is "finished" defined for this application? The walls and floor...

Wood Basements [ 1 Answers ]

How do I stop the noise from my well pump where the plastic pipe enters through the wall ? It a vibrating noise

Basements/ejector pumps/washers [ 11 Answers ]

A twist on a familiar question posted here... I am attempting to move my washer/dryer into my basement. It is rough plumbed for a bath, with a 4 inch waste line dumping into a sewage ejector pit. Can I cut a tee into that 4 inch waste line and route my 2 inch washer drain line into it? I am...


View more questions Search