 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
GE Washer Fills and Spins but does not Agitate
I have little experience with appliances, but before getting a new washer, I was wondering what might cause a GE washer to be able to spin and fill, but not agitate. Could it be something that I could fix on my own? I hear and see it trying to agitate, but it kind of makes a whirring noise and doesn't move when it is on the agitate cycle.
|
||||
|
||||
|
Disconnect the power. If the wsher does spin but does not agitate, check the agitator splines. They may be wore out. Turn the transmission pulley in both directions If it will not turn in both directions it is bad. This is a costly repair even if you choose to do it yourself. Weight the cost of repair and age of unit vs new one. If the trans pulley turns fairly easily by hand, but the clutch drum is turning slowly or not at all under motor powr the clutch may be bad. Usually there will be a loud rattling noise. These are things to check out that could be causing your problem. Hope this helps you out. Good Luck
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a Kenmore Washing machine model # 110.2463200 , when you try to wash a load it fills up with water but then it stops. It won't finish the cycle. What do I do to fix this. Is it the lid switch? If so how do I fix that?
After the wash cycle the washer makes a sound but doesn't spin, it does drain the water out though. If you lift the lid and shut it then the spinning starts... anyone have any ideas before I call stupid whirlpool. Thanks Tiffany
My wife had a problem with our Kenmore washer model number 110.26914691 with water all over the floor during a large cycle. I took it outside and checked to see if there were any leaks in the hoses or tub. There were none. I removed the cabinet and ran a small load test cycle. I was able to confirm...
View more questions Search
|
