[dp2763]

My wife had a problem with our Kenmore washer model number 110.26914691 with water all over the floor during a large cycle. I took it outside and checked to see if there were any leaks in the hoses or tub. There were none. I removed the cabinet and ran a small load test cycle. I was able to confirm that the washer fills, agitates drains and spins with no leaks from the plumbing or tub. The only thing that I think might be wrong is that when it goes into drain cycle it spins at the same time. I was always under the impression that it should drain first and then spin. Therefore, maybe with a large load it is sending water over the top when spinning. Does anyone know what might be wrong? Thank you!

[andrewcocke]

The washer should drain and begin the spin at the same time, however it takes a short while for the spin to get up to full speed. However I won't say that your tub might be overfilling.

It could also be coming from your drain, on large loads, the drain line may become flooded and backup a slight bit, mine does that on large loads, spits a little water out of the drain pipe. Being on a concrete floor I never messed with it.

If it just started doing it, you may have a clog in the drain line. (if its coming from the drain line)