Ask Experts Questions for FREE Help !
Ask
    cowgirl61's Avatar
    cowgirl61 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Aug 14, 2007, 02:09 PM
    Changing from a Rudd to a Hunter thermostAT
    I bought a hunter 44360 digital thermostat to replace a Rudd.
    The Rudd was wired Y-Yellow, G-green, E-White, R- Red, B-Blue, and a brown on X.
    The Hunter has G, RC, RH, Y/O, W/B and Y1.
    I can't seem to get the outside fan to run.
    Also before changing the thermostat, the blower fan constantly runs.
    Please help me it is over 90 degrees in the house and in the 100"s outside.
    acetc's Avatar
    acetc Posts: 1,004, Reputation: 79
    Ultra Member
    		  
    #2

    Aug 14, 2007, 02:13 PM
    Did the fan run constantly before?
    acetc's Avatar
    acetc Posts: 1,004, Reputation: 79
    Ultra Member
    		  
    #3

    Aug 14, 2007, 02:18 PM
    Tape off the brown, it will not be used. This thermostat does not have two stage heat, which is what you need . If you connect to this thermostat you will have no aux. heat.(electric heat)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Changing over from White Rodgers Thermostat to Honeywell thermostat [ 3 Answers ]

I have a White Rodgers 2 stage heat/1 cool model 1F58-58 heat pump thermostat that I want to change over to a Honeywell programmable thermostat model RTH7400. I need help in trying to figure out the wiring part of this whole thing. Can someone out there please help. I would certainly appreciate...

Problems changing to digital thermostat (Hunter 33260) [ 1 Answers ]

I'm pretty good about reading other posts and I just couldn't find an answer for my situation... I bought my house last year in Arizona (very very hot now) and the thermostat looked like the same one from when the house was built 20-25 years ago. Deciding to do a cheap upgrade I purchased the...

Hunter Ceiling Fan Randomly Changing speeds. [ 17 Answers ]

I have a hunter Jackson Square ceiling fan on a wall remote kit that came with the unit. It randomly powers on and off and changes speeds. I have changed the frequency on the remote and receiver multiple times and it still does this. The house was prewired for this when I purchased the house so...

Changing from Rudd to Honeywell Thermostat [ 2 Answers ]

I am trying to change from a Rudd thermostat and system to a Honeywell RTH 7500 Thermostat. Having problems with the wiring as it does not work properly. The system that I have is a heat pump in the attic with auxiliary heat and an air conditioning system outside. I am not sure if this should be...

Need Help with Hunter Thermostat Please [ 4 Answers ]

I have a Payne PF1MNC hvac, and just replaced my White Rodgers thermostat (It wasn't blowing hot air or kicking in in Auto mode) with a Hunter 44155C. There were 4 wires attached: G to G R to Rh (with jumper) Y to Y1 W to W And an unattached B I attached them the same to the Hunter:

View more questions Search