 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Did you read the instructions pasted on the water heater right above the thermostatic valve ?
It is important that you TURN the small black button on top of thermostatic valve to OFF position... there is a small cut out in that button and that MUST align with the RED button positioned right next to it... then... PRESS that red, pilot lighting, button ALL the way down ( it should be pushed through that notch in the black button ) and keep holding it down ... WHILE lighting the pilot. Once the pilot is LIT, keep the red button PRESSED for at least 30 more seconds - then slowly release it. If the pilot dies - repeat. Try again Milo |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
My whirlpool hotwater heater has a blinking red light but no hot water, had nothing but trouble with it since I bought it. Have changed every part there is to change
I have a Beckett burner that will not start. I replaced the burner nozzle and when that didn't help I replaced the fuel pump, all with no result. The reset button flashes and I hold it for 15 seconds to release the lockout but nothing happens and the reset button continues to flash.
Rheem hot water heater gas. How to reset error codes. Eco code.
My hot water heater is a Gas heater made by State. It went to vacation mode yesterday and I followed instructions to reset it to normal range but it would not go. What could be the possible solution.
Reset button on hot water heater needs to be reset at times and I am wondering what the problem maybe, tank is a state select reset is within top panel on side of heater
View more questions Search
|
