Ask Experts Questions for FREE Help !
Ask
    marvelsf3333's Avatar
    marvelsf3333 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 30, 2015, 05:32 PM
    How do I test the gas valve on my American Gas boiler 1-6A-5E
    Replace the thermalcopling but pilot will not stay lit when I turn knob to on after lighting the pilot
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    Dec 1, 2015, 05:30 AM
    Does pilot lit stay lit after you release the button and before you turn to "ON"?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replaced the whole gas valve assembly, and still no gas to pilot valve. [ 2 Answers ]

I replaced the whole gas valve assembly. Checked the voltage according to the print. But I still can't get gas from the pilot valve. The model is 394gaz048I50

American standard furnace gas valve will not open [ 3 Answers ]

Gas valve test [ 3 Answers ]

Is there a way to test a gas valve on a roof top ac? Seems to me that when I went to AC school ( about 30 years ago) there was a way to check the pressure at a valve using a manometer. Is this possible are what? Frank

Hydrotherm boiler gas valve [ 2 Answers ]

I'm trying to find out how to connect back up a milli volt gas valve some one pulled the thermo coupling and aquastat wires off the gas control valve hydro therm gas boiler model # hc180 app manufacture date was 1976

Gas Valve pressure test [ 5 Answers ]

I just ordered a new gas valve for my fireplace. I damaged my old one by blowing compressed air into it to remove spiders that had found their way in through the gas orifice to the burner. Question: how do I test the water column pressure on the new valve, or do I assume it already comes pre-set...

View more questions Search