 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
ITT B67 gas valve for floor furnace
I have an Empire floor furnace with a B67 valve. The four terminal posts are labeled pilot generator-two posts- and two other posts that are labeled thermostat. The pilot comes on and stays on but the main burner will not come on. I am trying to use a Honelwell Pro 3000 series thermostat. This type of thermostat only has one output in the heat mode. Any ideas on how to wire this thermostat in. The original thermonstat was removed sveral years ago and this furnace has not been used for at least 10 years.
Thanks |
||||
Check out some similar questions!
Have a old gravity heat wall furnace with an ITT General Controls Gas Valve. The knob is missing and I can't tell where OFF, PILOT, or ON positions are. It's natual silver and brown. Does anyone have a old Manual or Picture? I can't tell what model, however B67 is mentioned quite a bit on line....
Hi. I just had my Empire direct vent wall heater connected (finally) after being installed for 10 yrs, but not being used. Didn't need it. Now I do. However, after lighting the pilot, the darn burner won't come on. It uses an ITT Gen. Controls B67 control valve. Took the orifice out and checked it...
I have a Duo-therm propane heater on a travel trailer. It has an ITT gas control valve with a 12V solenoid catalog no. 265044? or 28SD44? Anyway there are 2 screws to the left of the pilot adjustment red button and I am wondering what the initial settings for these screws should be? Thanks, ...
Help, I need wiring info for an old ITT general control gas valve on an outdoor swimming pool heater. The valve has 4 terminals, 2 labeled thermostat and 2 for the millivolt generator. I understand the safety devices get wired in series but I am not sure how the on/off switch and thermostat get...
Pilot light is on but it will not turn on via the thermostat. What should I look for?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
