Ask Experts Questions for FREE Help !
Ask
    magic4499's Avatar
    magic4499 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 22, 2013, 11:35 AM
    Need Manual or Picture of Old ITT General Control Gas Valve
    Have a old gravity heat wall furnace with an ITT General Controls Gas Valve. The knob is missing and I can't tell where OFF, PILOT, or ON positions are.
    It's natual silver and brown. Does anyone have a old Manual or Picture? I can't tell what model, however B67 is mentioned quite a bit on line.
    Any Info or Ideas are greatly appreciated, [email protected]
    Please help. Thanks
    cdad's Avatar
    cdad Posts: 12,700, Reputation: 1438
    Internet Research Expert
    		  
    #2

    Nov 22, 2013, 07:18 PM
    Have you tried calling or email here :

    Controls Supply 1-800-662-6663


    Most of what Im seeing says it is obsolete and replaced with a Robertson valve.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Itt gas control valve [ 0 Answers ]

I have a Duo-therm propane heater on a travel trailer. It has an ITT gas control valve with a 12V solenoid catalog no. 265044? or 28SD44? Anyway there are 2 screws to the left of the pilot adjustment red button and I am wondering what the initial settings for these screws should be? Thanks, ...

I have an old General Control Furnace Valve that doesn't work. [ 2 Answers ]

I have a General Control 24 Volt valve model 5-50 . I have replaced the thermocouple and the valve still doesn't open. I suspect the coil is faulty. Is there a replacement for this valve or can the coil be rebuilt? It has a standing pilot. The heat exchanger on this unit appears in good shape...

Need wiring schematic for an old itt general control gas valve [ 12 Answers ]

Help, I need wiring info for an old ITT general control gas valve on an outdoor swimming pool heater. The valve has 4 terminals, 2 labeled thermostat and 2 for the millivolt generator. I understand the safety devices get wired in series but I am not sure how the on/off switch and thermostat get...

General controls gas valve? [ 2 Answers ]

I have a General Controls B60Y64A123 Gas Valve on my Gas Furnace. I am replacing the Thermpile, but I am not sure what the Alum. Tube coming out of the gas valve and positioned next to the pilot is for. Please explain and does the end of the tube go in the flame or close to the flame. My gas valve...

ITT general controls gas valve with a Honeywell TS810B1007 [ 0 Answers ]

Pilot light is on but it will not turn on via the thermostat. What should I look for?

View more questions Search